Iran-Made Nano-Based Brake Pad Adhesive Exported to Turkiye
The Iran-made nano-based brake pad adhesive increases the durability of the pad and is produced at a lower cost than the foreign samples.
“This pad adhesive was imported from Turkiye to Iran in the past but it is now exported from Iran to Turkiye after development and mass-production,” said Mohammad Amir Negini, the commercial manager of the knowledge-based company.
Also, Seyed Abbas Hosseini Majd, the director of research and development of the company, said that the production stages of the adhesive include the combination of raw materials and synthesis inside the reactor, and then the separation of water and other materials.
“Next, the obtained solution is concentrated and nanomaterials are added to it. Then, depending on the type of adhesive grade, be it disc or roller, additives are added to it,” he added.
Hosseini Majd explained that the adhesive can tolerate a temperature of 400 degrees while the properties of the brake pad are still maintained.
In a relevant development in July, experts at an Iranian nanotechnology firm had also succeeded in manufacturing a new type of reinforcing adhesive which can be used for car body.
‘Ayegh Khodro Toos’ company has made the product which is an epoxy resin-based and solvent-free reinforcing adhesive containing nanoparticles.
It should be cured at temperatures above 140 C to become resistant against moisture, heat, extreme cold, and acidic and alkaline media.
The incorporation of nanoparticles in the epoxy resin matrix has resulted in improved flowability, adhesion strength, and heat flux, and enhanced wear resistance in a convenient and cost-effective way.
The product can be used as reinforcing adhesive for ceilings, doors, columns, and backs of the car.
4155/v
